How to Prepare Uneven Ground for Remote Control Lawn Mowing

The reader wants a practical prep routine for rough ground and a clear answer to whether a remote control mower suits their block. Intent is commercial-investigational: they are close to buying, so the article earns trust with real prep advice first and points to the shop second.

What page one covers today. Ranking pages are mostly robot-mower brand blogs (eufy, Sunseeker, FJDynamics) plus Gravely and Mowrator’s own US blog. They explain slope ratings and say “clear debris” in one line, then pivot to a product.

Where they are thin.

  • Almost none are written for New Zealand: no pugging, rabbit scrapes, kikuyu, wet winters, or lifestyle-block hazards like old waratahs and fence wire.
  • Robot-mower content assumes a fenced suburban lawn on a schedule. Remote control mowing on rough paddock edges is a different job.
  • Few explain how to actually measure a slope or turn degrees into a usable number.
  • “Prepare your lawn” is a bullet list, not a sequence with timing.

Angle. A walk-the-block, step-by-step prep method written for NZ conditions: survey, hazard-proof, fix ground, set cut height, then mow. Remote control is positioned as the safer tool for ground that should not be ridden on, backed by WorkSafe’s guidance on vehicles and slopes. One short section serves contractors maintaining solar farms.

Semantic terms woven in: slope gradient, ground clearance, traction, scalping, topdressing, lawn levelling, pugging, drainage, cutting height, all-wheel drive, operator safety, lifestyle block, paddock, berm, embankment, solar array.

Why uneven ground needs preparing before you mow

Rough ground causes three predictable problems. A rigid deck crossing a hump drops the blades into soil and scalps the turf, while hollows leave tufts the blades never reach. Objects hidden in long grass, such as stones, wire and stakes, damage blades and drive parts. And wet clay on a slope robs any machine of traction.

Remote control mowing changes the risk to the operator, not the ground. WorkSafe has repeatedly warned that vehicles on slopes are a leading cause of farm deaths; its review of vehicle-related farm fatalities found that more than half involved experienced farmers driving on sloping or uneven ground. Taking the person off the machine removes much of that danger. The mower itself still needs ground it can grip and nothing in its path that it can hit.

Step 1: Walk the block and map the problem areas

Before you touch a spade, walk every area you plan to mow. Take your phone and mark four things: steep sections, hollows and dips, humps and mounds, and spots that stay wet after rain.

A rough sketch or a printed satellite image of the property works well. Note which banks turn greasy in winter or after a frost, because a slope that is easy in February can be a different job in July.

How to measure the slope

You need a real number, not a guess. Two easy methods:

  • Phone app: lay your phone on a straight board resting on the slope and read the angle from a free inclinometer or spirit-level app.
  • Level and board: rest one end of a 1 m straight board on the slope, hold it level with a spirit level, and measure the gap to the ground at the other end. That gap over 1 m gives you the gradient.

Use this table to convert between the ways slopes are usually described:

Ratio (rise:run)DegreesPercent grade
1:511°20%
1:414°25%
1:318°33%
1:2.522°40%
1:227°50%
1:1.534°67%

Compare your steepest reading with the maximum slope rating in your mower’s specifications. Treat that rating as a ceiling, not a target for routine mowing, and leave a wider margin when the grass is wet.

Step 2: Clear hidden hazards from the mowing area

Long grass on rural property hides more than people expect. Walk the area in lines, a few metres apart, and look for:

  • Waratahs, old fence standards, wire and netting left from earlier fence lines
  • Rocks and river stones, especially on alluvial or recently worked ground
  • Branches, prunings and fallen limbs after a storm
  • Irrigation risers, sprinkler heads and hose fittings
  • Septic tank lids, soakage field markers and inspection points
  • Survey pegs, stakes and old tree guards
  • Stumps, rabbit holes and burrows

Remove what you can. Anything that must stay, such as a riser or a tank lid, should be marked clearly with a tall cane, flag or spray paint so you can steer around it. Wire deserves special attention, because it can wrap around a blade spindle in seconds. If you plan to dig out stumps or large rocks, check for buried cables and pipes first through beforeUdig.

Bring very long grass down in stages

If the grass is knee-high, don’t try to take it straight down to lawn height. Set the deck high, take the top off, and lower the height over the next few cuts. A common rule of thumb in turf care is to remove no more than about a third of the leaf at a time. Staging the cut also exposes the ground, so you can see the hollows and hazards you missed. Mowrator’s guide to cutting tall grass on uneven ground covers this technique in more detail.

Step 3: Fix the ground itself

You don’t need a bowling green. The goal is narrower: no hollows deep enough to trap a wheel, no humps tall enough to scalp, and no soft spots that turn into mud. Leave steep natural banks as they are. Those are exactly the areas a remote control mower is for.

Fill shallow dips with topdressing

For dips up to a few centimetres deep, spread a sandy topdressing or a sand and screened soil mix. Work it in with the back of a rake or a stiff broom so the grass tips still show. Apply no more than about 1–2 cm at a time, let the grass grow through, then repeat. Heavy single applications smother the turf.

Lift and relevel deeper hollows

For deeper hollows, cut an H or a cross through the turf with a spade, peel the flaps back, and add soil underneath. Firm it down, lay the turf back, and water it in. This is faster than topdressing in many thin layers and keeps the existing grass.

Flatten humps and old stump mounds

Humps work the same way in reverse. Lift the turf, remove soil until the surface sits level with its surroundings, then relay. Filled rabbit scrapes and burrows should be firmed well, or they will sink again after the first heavy rain.

Deal with pugging and wet ground

Where stock have been on clay over winter, the surface can be deeply pugged. Wait until the soil is firm but still slightly moist, then roll it lightly and oversow the bare patches. If water sits in the same spot after every rain, the long-term fix is drainage, not more soil. Avoid mowing saturated ground at all; tyres rut, slip and leave marks that take months to grow out.

Step 4: Set up your mower for rough terrain

Once the ground is ready, a few minutes of setup prevents most problems on the first cut:

  • Raise the cutting height. A higher cut leaves room for the deck to ride over small bumps without scalping.
  • Check the blades. Sharp blades cut cleanly; blunt ones tear grass and work the motor harder on slopes.
  • Clean the wheels or tracks. Caked mud cuts grip noticeably.
  • Check ground clearance against your bumps. If the underside drags on a hump, fix the hump or avoid it.
  • Charge fully and plan your route. Running low halfway across a bank is awkward with any machine.
  • Read the manual’s slope and range guidance. Operating limits differ between models.

If you are still choosing a machine, the features that matter most for remote control lawn mower uneven terrain work are all-wheel drive, a slope rating comfortably above your steepest reading, good ground clearance, and an adjustable cutting height. You can compare these across the Mowrator NZ remote control mower range.

Step 5: Mowing rough ground safely

With the ground prepared and the mower set up, these habits keep mowing rough ground safe and the finish even:

  • Mow when it’s dry. Late morning or early afternoon, after dew has burned off, gives the best traction.
  • Start on the gentlest section. Learn how the mower handles before you take it onto the steepest bank.
  • Follow your manufacturer’s direction on slopes. Whether you mow up and down or across, avoid sharp turns on the steepest part. WorkSafe’s guidance for using the right farm vehicle advises turning uphill when working across slopes, and that principle applies here too.
  • Keep a clear line of sight. Stand where you can see the mower and the ground ahead of it, outside the mowing area.
  • Keep people, pets and stock away. Clear the paddock or close gates before you start.
  • Slow down over rough patches. Speed turns small bumps into big bounces.

Ongoing uneven lawn maintenance through the NZ year

Ground settles, rabbits dig and stock pug the edges, so preparation is never one-and-done. A light seasonal routine keeps the work small:

SeasonWhat to do
Spring (Sep–Nov)Topdress dips, oversow bare patches, start the season with a high cut
Summer (Dec–Feb)Mow higher in dry spells; ground is firm, so it’s a good time to check for new humps
Autumn (Mar–May)Main window for levelling and relaying turf while soil is warm and moist
Winter (Jun–Aug)Avoid wet clay slopes, check drainage, service blades and the mower

Spring and autumn are the best times for real lawn preparation in NZ, because grass recovers quickly when it’s growing actively.

For contractors: preparing solar farm sites

Landscaping contractors maintaining grass on solar farms face the same principles with different obstacles. Before the first visit:

  • Walk the rows and confirm clearance under the lowest panel edges.
  • Mark cable runs, junction boxes, inverter pads and earthing points.
  • Agree exclusion zones and access times with the site operator.
  • Note pugging if the site is also grazed, and fill it before mowing.

Remote control mowing lets the operator stay outside the tight rows while the mower works between them, which keeps people away from both the machine and the electrical infrastructure.

Common mistakes to avoid

  • Dropping long grass to final height in one pass. It scalps the high spots and stresses the grass.
  • Mowing wet clay. It ruins traction and the turf.
  • Treating the maximum slope rating as normal. Work well below it.
  • Skipping the walk-through. One hidden waratah can cost more than the whole prep.
  • Over-levelling. Thick topdressing smothers grass; thin layers win.

Frequently asked questions

Can a remote control mower handle uneven ground?

Yes. Remote control mowers are built for rough, sloping ground, but only within their rated slope and ground clearance. Clearing hazards and filling deep hollows first gives a cleaner cut and protects the mower.

Do I need to level my lawn before using a remote control mower?

Not completely. Remove hidden objects, fill hollows deep enough to trap a wheel, and flatten humps that scalp. Natural slopes and gentle undulations can stay.

What is the best time of year to level a lawn in New Zealand?

Autumn and spring. Soil is warm and moist and grass is growing, so topdressing and relaid turf recover quickly. Avoid levelling in mid-summer dry spells or on waterlogged winter ground.

How steep a slope can I mow safely?

It depends on your mower’s rated maximum slope. Measure your steepest area, compare it with the rating, and stay comfortably below the limit, especially when grass is wet.

How do I fill dips in an uneven lawn?

For shallow dips, apply sandy topdressing in layers of about 1–2 cm and let grass grow through between applications. For deeper hollows, lift the turf, add soil underneath, and relay it.

Should I cut long grass before levelling the ground?

Yes. Bring it down in stages with a high cut first. Shorter grass lets you see hollows, humps and hazards before you start fixing the surface.

Is remote control mowing safer than a ride-on on slopes?

It removes the operator from the machine, which takes away the main risk of a rollover injuring the person. Safe practice still matters: mow in dry conditions, keep a clear line of sight, and stay within the mower’s limits.

Get your uneven ground ready, then let the mower do the hard part

Preparing uneven ground for mowing comes down to five steps: map the block, clear the hazards, fix the worst of the ground, set the mower up for rough terrain, and mow in the right conditions. Do that once properly, keep up a light seasonal routine, and the steep banks and lumpy paddock edges stop being the job you put off.

When your ground is ready, explore remote control mowers built for NZ slopes or visit Mowrator NZ to find the right machine for your property.

Home Shop Cart 0 Wishlist Account
Shopping Cart (0)

No products in the cart. No products in the cart.